Table of Contents
Advertisement
HOW TO TURN ON THE POWER
HOW TO USE THE MANUAL MODE
iMPORTANT: if the elliptical
has been exposed to
cold temperatures,
allow it to warm to room tern=
perature before turning on the power, if you do not
do this, you may damage the console displays or
other electrical components.
Plug in the power cord (see
HOW TO PLUG iN THE
POWER CORD on page
14). Next, locate the
power switch on the frame
near the power cord. Press
the power switch to the
reset position.
Reset
Position
The display will then light and the console will be ready
for use.
Note: When you turn on the power for the first time,
the ramp will calibrate automatically.
The ramp will
move upward and downward as it calibrates. When the
ramp stops moving, the ramp is calibrated.
IMPORTANT:
if the ramp does not calibrate auto=
matically,
see HOW TO CALIBRATE THE RAMP on
page 24 and manually
calibrate the ramp.
1.
Begin pedaling or press any button on the
console to turn on the console.
See HOW TO TURN ON THE POWER at the left.
2.
Select the manual mode.
Press the Manual Control button on the console to
select the manual mode.
if a wireless iFit Live module is not inserted into
the console and connected to iFit Live, the manual
mode will be selected automatically.
3.
Change the resistance of the pedals and the
incline of the ramp as desired.
As you pedal, change the resistance of the pedals
by pressing the Resistance increase and decrease
buttons located on the console or on the right
handlebar.
Note: After you press a button, it will take a
moment for the pedals to reach the selected resis-
tance level.
To vary the motion of the pedals, you can change
the incline of the ramp. To change the incline,
press one of the numbered 1 Step Power Ramp
buttons or press the 1 Step Power Ramp increase
and decrease buttons located on the console or on
the left handlebar.
Note: After you press a button, it will take a
moment for the ramp to reach the selected incline
level.
17
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
