Table of Contents
Advertisement
PLAYBACK
OF PRE-RECORDED
CASSETTE
Symptom
Check Point & Correction
"PLAY"
Button cannot be engaged.
* Set "VCR/CAM"
Select Switch
to "VCR"
po-
sition.
No picture appears on television screen when "PLAY"
* Set the television to the Camera/Recorder channel
Button is pressed.
(3 or 4) depending upon the selected channel on the
(TV is connected to the Camera/Recorder by using RF
RF Channel Select Switch of RF Converter Unit.
Converter Unit.)
Interference on playback picture.
Picture
bends at the top of TV screen.
* Adjust "TRACKING"
Control.
When you see the playback picture on your "IV,
adjust fine tuning knob on television set to obtain
best picture.
* The pre-recorded tape is LP or EP recording.
This Camera/Recorder
is for use in SP recording
only.
* Take the Camera/Recorder to Sears Service Center
for service.
Color of your TV screen is too bright, too faint or
*
change.
DEW
LIGHT
Symptom
Check Point & Correction
"DEW (POWER)"
Light flashes.
* Condensation on the Camera/Recorder mechanism
-- wait until the Unit has reached normal room
temperature, and condensation has dried.
"DEW (POWER)"
Light will then stop flashing.
BATTERY
CONDITION
Symptom
Check Point & Correction
The "E" indication in the ElectronicViewfinder flashes
* Try another Battery or charge the Battery.
to indicate Battery is discharged.
TV receiver is of older type. it needs to be modified
to work properly with Camera/Recorder,
Tape is damaged,
Try another cassette.
TV set has VIR circuit.
Turn it off during playback.
STORING
THE CAMERA/RECORDER
IN THE CARRYING
CASE
1, Place the cassette
tape in the area marked "CASSE'rI'E
TAPE".
(Do not store the tape in the Camera/Recorder.)
2. Place the Camera/Recorder
in the case.
(The handle should
be near the case handle
and the lens should
point
to the right.)
3. Slide the viewfinder
down as far as possible.
(Don't
force,)
Rotate the eyepiece
until it points
toward
the case
handle.
The viewfinder
will now slide down
a little further.
Advertisement
Table of Contents
