Table of Contents
Advertisement
CHARGING THE BATTERY PACK
1. Plug the AC Adaptor/Charger
(Accessory
No. 3)
loower cord into AC electrical outlet.
2. Attach
the Battery to the AC Adaptor/Charger.
Align the reference arrow on the Battery with that of
AC Adaptor/Charger
and push the Battery flush with
the AC Adaptor/Charger
and slide it in the direction
of arrow.
NOTE: When
a Battery is attached
to
the AC
Adaptor/Charger,
do not turn them upside down.
The Battery may fall off and be damaged or cause
injury.
3. The "CHARGE"
Light will be lit while the Battery is
accepting a charge, and will go out when the Battery
is fully charged.
"CHARGE"
Light
"POWER"
Light
NOTES:
1. The time required for charging the Battery
is
approx, two hours.
2. When fully charged, the Battery should supply
approx. 45 - 60 minutes of operating time (de-
pending on how much you use zoom and pause).
3. An optional long play battery (Sears Stock No.
57-53982) may also be charged by the AC Adap-
tor/Charger.
The time for battery charging is ap-
prox. three hours.
4. Charge the Battery after use and store it at nor-
mal room temperature.
5. Recharge your Battery at least once every six
months. The Battery is a Lead-acid Battery.
This Battery tends to discharge if not used for an
extended period of time. If the Battery is stored
for a extended length of time without being
recharged, you may not be able to recharge it,
6. A Battery charged after being stored for a long
period may not supply power for the specified
time. Additional rechargingswill help restore the
Battery's operation time.
7, The Battery should be charged at a temperature
of 32°F
--
95°F (0°C --
35°C) to prevent
damage.
8. Do not operate the Battery at temperatures be-
low 14°F (--10°C)
or above 95°F (35°C).
The
Battery may be damaged if operated at temper-
atures above 122°F (50°C). Operation time will
decrease at extremely low temperatures.
9. After repeated chargings and use, the operation
time will gradually decrease.
When operation
time becomes too short to be useful, it is time to
replace the Battery.
10. If "CHARGE"
and "POWER"
Lights on the AC
Adaptor/Charger
start flashing, remove the bat-
tery and then reattach it.
If after several at-
tempts both Lights continue to flash, this means
your battery cannot take a charge and must be
replaced with a new one.
Both Lights will also flash if a hot battery is at-
tached to the AC Adaptor/Charger.
Attaching
an extremely hot Battery to the AC Adaptor/
Charger is not recommended;
it should be al-
lowed to cool down before being attached.
11. Do not short the Battery's terminal.
12. Do not attempt to disassemble or modify the Bat-
tery.
There are no userserviceable
parts inside.
13. Throwing the Battery into a fire or exposing the
Battery to excessive heat -- over 149°F (65°C)
could be hazardous.
--10--
Advertisement
Table of Contents
