Making A Sample Camera Recording; Connected - Sears LXI series 580.55914490 Owner's Manual

MAKING A SAMPLE CAMERA RECORDING
1. Connect the POWER SOURCE. (See page 6.)
2. Slide "CAM/OFF/VCR" select switch to "CAM"
and press the "EJECT" button, and the cassette
holder will open.
NOTE: If the power source is not connected to
the video camcorder, the cassette holder will not
open.
"EJECT"Bu_on
"CAM/OFF/VCR"
Select Switch
3. Insert the cassette so the transparent window is
facing out and the arrow toward the cassette
holder. Slide the cassette into cassette holder as
far as it will go. Then, press the cassette holder
shut.
The holder will latch in the operating position.
Cassette Holder
"FOCUS
AUTO/MANUAL" Switch
,
.
Now, press "RECORD Start/Stop" button to start
shooting the picture. "REC" indication appears in
the viewfinder and you are now recording the
picture you see through the viewfinder.
Press "Record Start/Stop" button to stop record-
ing.
The "PAUSE" indication in the viewfinder appears
instead of "REC" in the record/pause (stand-by)
mode. Press this button again to resume record-
ing.
"RECORD
START/STOP" Button
4. The video camcorder will enter record/pause
mode automatically.
NOTE: If the erase prevention tab on the
cassette is removed or no cassette is inserted,
the "TAPE" indication in the viewfinder flashes.
8. After recording, set "CAM/OFF/VCR", switch to
"VCR" and the video camcorder will be now in
the stop mode.
5. Set "FOCUS AUTO/MANUAL" switch to "AUTO".
NOTE: See page 24 for "EYEPIECE ADJUST-
MENT".
10