Table of Contents
Advertisement
[] WHEN USING WITH THE CAR BATTERY
To cigarette
lighter
socket
Car Battery Cord I*)
To "'DC IN 9.6V"
1. Connect the small plug of the Car Battery Cord to the
"'DC IN 9.6V" jack of the Camera/Recorder.
2. Connect the other of the Car Battery Cord to the
car's cigarette lighter socket.
(*) Optional-- not supplied.
See page 2 for ordering information.
NOTES:
The Car Battery Cord is designed to be used
only with automobiles having a 12-volt negative
ground system.
To avoid possible damage to your Camera/
Recorder, make sure the Car Battery Cord you
plan to use has posil_ve tip polarity and is
capable of converting 12 volts to 9.6 volts such
as Sears Part No. 46-23858-3.
BATTERY PACK CHECKING
When the "E"
indication in the Electronic Viewfinder
appears and flashes while the Video Camera/Recorder
is operated with a Battery pack (Accessory No. 2) dur-
ing recording, it indicates that the battery charge is in-
sufficient.
Then, charge it or replace it with a charged
battery pack.
NOTE: Whenever the linear time counter or tape re-
maining display is present in the viewfinder, it appears
with
a 3-dash read-out indicating
the condition
of
Camera/Recorder
battery power.
When the battery is
fully charged, the display reads "E------F".
When the battery is very near empty, only one dash re-
mains and starts blinking.
You should find an alterna-
tive power
source or recharge
the battery
before
continuing to use your Camera/Recorder.
E-_-F
0:O0:00
0:00:00
-9-
Advertisement
Table of Contents
