Registering A Unit; Additional Handsets - Panasonic KX-TG6711NZ Operating Instructions Manual

Setting call restriction
You can restrict selected handsets from
dialling certain numbers. You can assign up to
6 phone numbers to be restricted, and select
which handsets are to be restricted. Storing
area codes here prevents the restricted
handsets from dialling any phone number in
that area code.
1
#256
2
Enter the base unit PIN (default: "0000").
R If you forget your PIN, contact an
authorised service centre.
3
Select the handsets to be restricted by
pressing 1 to 6.
R All handsets registered to the base unit
are displayed.
R " " is displayed next to the selected
handset numbers.
R To cancel a selected handset, press
the same dial key again. " "
disappears.
4
5
Select a memory location by pressing 1
to 6. a
6
Enter the phone number or area code to
be restricted (8 digits max.). a
M N
R To erase a restricted number, press
.
Changing the base unit PIN
(Personal Identification Number)
Important:
R If you change the PIN, please make note of
your new PIN. The unit will not reveal the
PIN to you. If you forget your PIN, contact
an authorised service centre.
1
#132
2
Enter the current 4-digit base unit PIN
(default: "0000").
3
Enter the new 4-digit base unit PIN. a
a M N
TG6711_21NZ(en)_0216_ver011.pdf

Registering a unit

Operating additional units

Additional handsets

Up to 6 handsets can be registered to the
base unit.
Important:
R The additional handset model
recommended for use with this unit is noted
on page 5. If another handset model is
used, certain operations (handset settings,
base unit settings, etc.) may not be
available.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit (for example,
is displayed even when the handset is
near the base unit), re-register the handset.
1
Handset:
a
2
Base unit:
Proceed with the operation for your
model.
n KX-TG6711 series: page 3
n KX-TG6721 series: page 3
R If all registered handsets start ringing,
R The next step must be completed
3
Handset:
displayed. a Enter the base unit PIN
(default: "0000"). a
R If you forget your PIN, contact an
31
Programming
#130
Press and hold M N for about 5
seconds. (No registration tone)
Press and hold M N for about 5
seconds, until the registration tone
sounds.
press M N again to stop, then repeat
this step.
within 90 seconds.
a Wait until "Base PIN" is
authorised service centre.
2012/02/17 15:48:57
31