Section 8: Installing The Accessories; Installing The H34Df* Log Set - Montigo H34DF Installation & Maintenance Manual

H*34DF Indoor Gas Fireplace

Section 8: Installing the accessories

Installing the H34DF* Log Set

Installing the Logs:
The H34DF* fireplace is supplied with five ceramic fibre logs. Unpack
the logs and handle them very carefully.
Step 1. Remove the glass door as described in the previous instruction.
Pilot Assembly
Air Inlets
Fireplace Base
Figure 28a. H34DF*'s Fireplace Base.
Step 2. Install Bottom Rear log as shown in Figure 28b.
Rear / Bottom Log
Log stand
Fireplace Base
Figure 28b. Bottom/Rear log placement.
Step 3. Install Both front base logs, (Figure 28c) on the log stands
provided. See Figure 28b.
Notch
Front Left
Base Log
Fireplace Base
Figure 28c. Front base logs placement.
XW2044
Page 22
Installation
Notch in Log
Log stand
Notch
Front Right
Base Log
NOTICE
If logs are not placed properly, excessive
sooting will result.
Step 4. Place the top left log as shown in figure 28d. A flat area is
provided on the front left log, and a notch in the Rear bottom
log, as shown in figure 28c. Install the glass door. If the flame
does not appear satisfactory, double-check the air inlet and
exhaust outlet pipe to ensure that they are unobstructed.
Top Left Log
Fireplace Base
Figure 28d. Top Left log placement.
Step 5. Place the top right log as shown in figure 28e. A notch is provided
on the front right log, and a impression in the Rear bottom log.
Figure 28e. Top right log placement.
Step 6. Start the fireplace. If the flame appears satisfactory, replace
the glass door. If the flame does not appear satisfactory,
double-check the air inlet and exhaust outlet pipe to ensure
that they are unobstructed.
Embers
Figure 28f. Placing Embers.
Step 7. Place the Embers as shown in figure 28f. Arrange the ember chips
on top of the burner tray. Care should be taken when placing the
embers, as blocked burner ports may cause an incorrect flame
pattern, carbon deposits and delayed ignition. Also, the embers
must nEVER be placed in a way that obstructs any of the air inlet
ports, located at the rear of the burner, as shown in figure 28a.
Notch
Top Right Log
Top Right Log
Embers
Embers
XG0146 - 050211.1