Test Run - Grizzly GO739 Owner's Manual

Test Run

once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
Note: You do not need to install a drum to perform
the test run.
the test run consists of verifying the following:
1) the motor powers up and runs correctly, and
2) the safety disabling mechanism on the switch
works correctly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on Page 22.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
To test run the machine:
1.
Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is assembled properly.
2.
Make sure all tools and objects used during
setup are cleared away from the machine.
3.
Connect the machine to the power source.
4.
Verify that the machine is operating correctly
by turning it ON.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
5. turn the machine OFF.
Model g0739 (Mfg. since 2/12)
where children may be present.
IMPORTANT: Disabling the switch only
restricts its function. It is not a substitute
for disconnecting machine from power when
6. remove the switch disabling key, as shown
adjusting or servicing.
in figure 11.
figure 11. disabling switch by removing key.
7. try to start the machine with the paddle
switch.
—if the machine does not start, the switch
disabling feature is working as designed.
—if the machine does start, immediately
disconnect power. the switch disabling
feature is not working correctly. this safety
feature must work properly before pro-
ceeding with regular operations. Call tech
support for help.
Congratulations! the test run is complete.
the sander is ready for operation.
-15-