Table of Contents
Advertisement
SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
failure to do this may
result in serious person-
al injury.
Schedule
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
before Each use
•
inspect the sanding drums and sleeves for
wear or damage.
•
Check for worn or damaged wires.
•
Check for any other unsafe condition that
could hamper operation of this machine or
cause potential injury.
After Each use
turn the sander OFF.
•
•
Clean up any sawdust or particle residue
from the machine.
•
protect table.
Monthly Maintenance
•
Clean/vacuum dust buildup from inside the
sander body and off of the motor.
Model g0739 (Mfg. since 2/12)
Cleaning
to clean your machine, vacuum excess wood
chips and sawdust, and wipe off any remaining
dust with a dry cloth. sawdust and other particles
can also work their way under the table insert,
so this area also needs to be cleaned. sanding
sleeves can be cleaned with the pro-stiK
cleaners on Page 20.
To clean the table:
1.
disConnECt sAndEr FroM poWEr.
2.
remove sanding drum and table insert as
described in Step 1 of the Sanding Drum
Installation instructions on Page 18.
3.
Wipe or vacuum out any dust or particles that
have accumulated beneath the table insert
on the table opening, shown in figure 18.
4.
re-install table insert and sanding drum.
table opening Base Washer
table insert
sanding drum
and sleeve
figure 18. table insert area.
5.
to protect the table from rust, coat the table
surface with a quality metal protectant.
®
spindle
Washer
spindle
hex nut
-19-
Advertisement
Table of Contents
