Electrical Connection - Miele CM 5200 Operating Instructions Manual

Electrical connection

All electrical work should be
performed by a qualified electrician
in strict accordance with national
and local safety regulations.
Installation, repairs and other work
by unqualified persons could be
dangerous.
Verify that the voltage, load and circuit
rating information found on the data
plate match the household electrical
supply. This data must match to
prevent damage to the coffee system. If
in doubt, consult a licensed electrician.
The data plate can be found behind the
drip tray inside the coffee system.
The plug will fit in the outlet only one
way. If it does not fit, DO NOT use force
and DO NOT modify the plug in any
way. Contact a qualified electrician.
The socket should be located next to
the machine and be easily accessible.
If the appliance is connected to the
electrical supply with an extension cord
please note:
– A short power-supply cord is to be
provided to reduce risks resulting
from becoming entangled in or
tripping over a longer cord.
– Always use care and exercise
caution with using an extension cord.
– The marked electrical rating of the
extension cord should be at least as
great as the electrical rating of the
appliance.
– The extension cord should be a
grounding-type 3-wire cord.
76
– A longer cord should be arranged so
that it will not drape over the counter
top or table top where it can be
pulled on by children or tripped over.
Do not connect the appliance to a
power inverter or directly to power
produced outside of the normal
electrical grid (i.e. direct solar or wind
power source).
Direct connection to such power
sources can cause power surges and
tripped breakers when the appliance is
turned on, and could damage the
appliance.
Do not connect the appliance to energy
saving plugs or outlets. The reduction
of power to the appliance caused by
these devices will cause the appliance
to run hot and may damage it and/or
shorten its usable life.
Do not operate any appliance with a
damaged cord or plug. Contact Miele
Technical Service.
If there is any question concerning
the electrical connection of this
appliance to your power supply,
please consult a licensed electrician
or contact Miele's Technical Service
Department. See back page for
contact information.
WARNING:
THIS APPLIANCE MUST BE
GROUNDED