Assembly - Shindaiwa BCK-10A Instructions Manual

Assembly

Remove Cutting Attachment
1. Turn the unit over so that the gearcase output shaft faces UP.
Gearcase with noteched flange:
2. Align the hole in the holder with the notch in the gearcase flange, and then
temporarily lock the output shaft by inserting a hex wrench through both
holes.
Gearcase with side-mounted locking hole:
3. Align the notch in trimmer head holder T with the notch in the gear case
flange. Lock the holder and output shaft by inserting a hex wrench through
the locking hole in the gear case and into the aligned notches.
4. While holding the hex wrench turn the trimmer head clockwise to remove.
5. Remove the hex wrench.
6. Remove trimmer head holder (F) or (T).
Removing the Existing Cutting Attachment Shield
1. Remove the four socket-head cap screws (A), upper
clamp (B), and two shims (C).
2. Remove the cutting attachment shield from the
gearcase.
4
A
C
F
26107
B
C
T