Before You Start; Assembly - Shindaiwa BP420S Operator's Manual

Before you start

Assembly

Read the operator's manual carefully to ensure that you assemble the product correctly.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
1. Power transmission
shaft (F)
2. Holder
3. Power transmission
shaft (R)
4. Spacer
1. Lock pin
2. Push
1. Joint
2. Inner cable
3. Holder
4. Lead (A)
WARNING
5. Connector
6. Socket
7. Bolt
3. Power transmission
shaft (R)
5. Lead (B)
6. Throttle cable
7. Cover (A)
8. Cover (B)
Before you start
Flexible shaft assembly
First stage of assembling is coupling of the power transmission
shaft (F) and (R).
Loosen bolt with hexagonal wrench.
Insert the power transmission shaft (R) with the spacer into the
socket gradually and fully. - The socket is assembled on the
power transmission shaft (F) and located inside of the rear
handle. - The spacer that is located at the end of the power
transmission shaft (R) prevents the shaft (R) from loosening
off.
Insert connector into holder and tighten bolt securely using
hexagonal wrench.
Second stage is coupling of the power transmission shaft (R) and
the engine.
As pushing in the lock pin fully, insert the other end of power
transmission (R) to the driving shaft of the engine. - For easier
coupling, pull out the power transmission (R) about 4 mm
more in advance.
After set the lock pin free, confirm that the flexible shaft as-
sembly can not be drawn out and is coupled properly with the
engine.
Throttle cable retainer assembly
This assembly is designed to provide a simple connection and
adjustment for the throttle cable.
Hook inner cable terminal into joint, set the cable in holder and
shut cover (A).
Connect lead (A) and lead (B).
16