General Safety Instructions; Safety Labels; Kit Contents - Shindaiwa BCK-10A Instructions Manual

Safety Labels

General Safety Instructions

WARNING!
■
When operating with a blade, make sure the handle
is positioned to provide you with maximum protec-
tion from contacting the blade. Always make sure the
handlebar is installed in accordance with the manufac-
turers instruction.
■
NEVER use a cracked or warped blade: If a properly
installed blade vibrates, replace it with a new one and
re-check.

Kit Contents

5
9
6
10
10
7
22
15
21
27
10
23
2
14
8
10
11
13
16
18
17
19
20
12
24
25
26
Safety and Operation Information Labels: Make sure
all information labels are undamaged and readable.
Immediately replace damaged or missing information
labels. A new label is provided in this kit and additional
labels are available from your local authorized Shin-
daiwa dealer. Prior to installing the new label, Remove
old label and clean the outer tube with rubbing alcohol
or similar cleaner.
■
ALWAYS Shut off the engine immediately if a blade
binds in a cut. Push the branch or tree to ease the
bind and free the blade.
■
Beware of a coasting blade when brushcutting.
A coasting blade can injure while it continues to
spin after the throttle trigger is released or after the
engine is stopped.
1
3
4
IMPORTANT!
# Description
1 Shoulder Strap w/ hip pad
2 Hanger
3 5mm x 12mm HSH Screw
4 5mm Hex Nut
5 Handle Bar Assembly
6 Caution Label
7 Upper Handlebar Cap
8 Handlebar Mounting Bracket
9 Lower Handlebar Cap
10 Hex Soc. Head Bolts, 5mm x 25mm 6
11 5mm x 45mm Bolts
12 Debris Shield
13 Debris Shield Extension
14 Spacer
15 Holder (A1)
16 Holder (B1)
17 Bolt Guard (C1)
18 Hex Head Bolt 7mm x 20mm w/
lock washer (D1)
19 Hex Head Bolt w/Flat Washer
7 mm x 24 mm (D2)
20 Holder/Bolt Guard (B2)
21 Holder (A2) (small-36 mm)
22 Shaft Cushion
23 Upper Clamp
24 7 mm x 26 mm Bolt (D3)
25 Bolt Guard (C3)
26 Holder (B3)
27 Clip
Assembly Tool (s)
Qty
1
1
1
1
1
1
1
1
1
4
1
1
2
1
1
1
1
1
1
1
1
1
1
1
1
1
3