Delta 410 Control Panel Software - Pc - M-Audio Delta 410 Manual

application to pan audio left and right under software control. To send a signal to
a Delta ASIO output 1 (for example) as a mono output send, one would choose
"Analog 1/2 Delta-410" for that track's output port, and then pan that output hard
left. These outputs are named as follows:
Analog 1/2 Delta-410
Analog 3/4 Delta-410
Analog 5/6 Delta-410
Analog 7/8 Delta-410
S/PDIF L/R Delta-410
WINDOWS MULTIMEDIA SETTINGS: Windows may be set up to use the
Delta 410 as its default audio device, allowing system sounds to be sent out the
Delta 410. This also enables you to use the Delta 410 with the sound applets
included with Windows. To set this up, go to Control Panel | Multimedia. In the
Audio Properties page, set the Playback and Recording devices to the Delta 410
input and output devices of your choice.
MACINTOSH SOUND MANAGER INPUTS AND OUTPUTS: The Apple
Sound Manager limits the user to one stereo pair for input and one stereo pair for
output. Within your music software, the device selection when using the Sound
Manager drivers for input and output will be "Sound Manager" both for input
source and for output port.
To select the Sound Manager driver, open the Apple Menu and go to Control
Panel | Sounds. For both "Sound In"and "Sound Out," click and highlight the
Delta icon, then exit. You may select which Delta hardware stereo input pair and
stereo output pair will be used for the Sound Manager's Sound In and Sound Out
in the Delta Control Panel "Hardware Settings Page" (see section, "Hardware
Settings Page"under "Delta Control Panel"). Whichever stereo pair you select,
the software input and output device selection within your music program will
remain the same.

Delta 410 Control Panel Software - PC

Once the Delta 410 is properly installed, an "M Audio Delta H/W" icon will be
displayed in your Windows Control Panel. By double-clicking on that icon, you
will launch the Delta Control Panel software. You may also launch the Delta
Control Panel software from the desktop if you have previously created a
shortcut there (see "Verifying Delta Control Panel Software Installation" section
for instructions on how to do this). Once the Delta Control Panel software has
been opened, you will see the main panel and its several tabs. To display a
desired page, click on its tab. Below are functional descriptions of each page.
16