Delta Tdif Control Panel Software - M-Audio Delta TDIF Manual

Pci audio card

Hide thumbs Also See for Delta TDIF:

Bedienungsanleitung (24 pages)

Table of Contents

TDIF In8 Delta-TDIF

SP/ANA In L Delta-TDIF

SP/ANA In R Delta-TDIF

Mon. Mixer L Delta-TDIF

Mon. Mixer R Delta-TDIF

Notice the SP/ANA In and Monitor Mixer names include "L" and "R"

characters. "L" indicates the left channel of the stereo stream, while "R"

indicates right channel.

ASIO DRIVER OUTPUT DEVICES: The Delta TDIF's ASIO output devices

appear in stereo pairs. Because each device is stereo, you may see "left" and

"right" references within your software application. This allows the

application to pan audio left and right under software control. To send a

signal to a Delta ASIO output 1 (for example) as a mono output send, one

would choose "TDIF 1/2 Delta-TDIF" for that track's output port, and then

pan that output hard left. The ASIO outputs are named as follows:

TDIF 1/2 Delta-TDIF

TDIF 3/4 Delta-TDIF

TDIF 5/6 Delta-TDIF

TDIF 7/8 Delta-TDIF

SP/ANA L/R Delta-TDIF

WINDOWS MULTIMEDIA SETTINGS: Windows may be set up to use

the Delta TDIF as its default audio device, allowing system sounds to be sent

out the Delta TDIF. This also enables you to use the Delta TDIF with the

sound applets included with Windows. To set this up, go to Control Panel |

Multimedia. In the Audio Properties page, set the Playback and Recording

devices to the Delta TDIF input and output devices of your choice. The

recomended choice is the SP/ANA output, using the Delta TDIF's analog

outs to monitor the system sounds.