Windows 3.1X Driver Control Panel; Audio Setup For Non-Pnp Computers - M-Audio DMAN Manual

Digital audio card

Hide thumbs Also See for DMAN:

Table of Contents

Windows 3.1x Driver Control Panel

After installation, various Windows 3.1x driver parameters may

be altered via the Drivers applet of the Control Panel. To open the

Drivers applet, first open the Control Panel (usually in the

Windows 3.1x Main group), then open the Drivers applet from

within the Control Panel. The DMAN actually installs and uses

two separate drivers for its digital audio and MIDI. The "DMAN

Digital Audio / Mixer Driver" handles the digital audio

recording and playback, as well as the on-board audio mixer. The

"DMAN MPU 401" controls the MIDI port (MPU401 "UART"

mode compatible). A typical Drivers dialog is pictured below.

Windows 3.1x Drivers Applet

If your computer has no PnP capability, or PnP is disabled, you

may modify the Windows 3.1x audio driver settings through the

Drivers Applet. First you must select the driver to set up by

highlighting "DMAN Digital Audio / Mixer Driver" entry, then

press the "Setup" button. The driver setup dialog will pop up.

Windows 3.1x Driver Setup - No PnP

Table of Contents