Transferring From Dat To Delta 410 - M-Audio Delta 410 Manual

Transferring from DAT to Delta 410

1. Connect the DAT's coaxial S/PDIF output to the S/PDIF In of the
Delta 410 PCI host card, using a good quality cable.
2. Connect the 410 analog outputs 1 & 2 to some type of amplified sound
system. The sound system should be equipped with speakers or
head-phones.
3. Because you will be recording from the S/PDIF input, you will need
to set up the Delta 410 to synchronize its master clock with the S/PDIF
input. To do this, open the Hardware Settings page of the control
panel software. Under Master Clock, select "S/PDIF In."
4. Next, you will need to tell your application software the expected
sample rate. We'll use 44.1 kHz in this example. Therefore, on the
Hardware Settings page, set the "S/PDIF Sample Rate" to 44,100.
44