Page Numbering - Lanier LD1110 Settings Manual

• Dup. Back Pg. Stamp Pos.
You can adjust the stamp position for back side in duplex mode, within the
available range as shown below.
Metric version:
• Left-Right: Left 432 mm – Right 432 mm
• Top-Bottom: Top 432 mm – Bottom 432 mm
Inch version:
• Left-Right: Left 17.0" – Right 17.0"
• Top-Bottom: Top 17.0" – Bottom 17.0"

Page Numbering

This section describes various items of [Page Numbering] under [Stamp].
❖ Stamp Format
You can select the page number format given priority when [Page Numbering]
is pressed.
• P1,P2...
• 1/5,2/5...
• -1-,-2-...
• P.1,P.2...
• 1,2...
• 1-1,1-2...
❖ Font
You can select the font in Page Numbering mode.
• Font 1
• Font 2
• Font 3
❖ Size
You can set the size of the stamp printed in Page Numbering mode.
• Auto
• Large
• Middle
• Small
❖ Duplex Back Page Stamping Position
You can set the position of the duplex back page number printed in Duplex
mode.
• Opposite Position
• Same Position
Stamp
4
137