Figure 3-11 Drive Power Supply And Ata Bus Interface Cables - Maxtor DiamondMax Plus9 60GB AT Product Manual

3.6.1.1 Connecting the Adapter Board and the Drive
Use a 40-pin cable/SATA cable to connect the drive to the board. See
figure 3-12.
Figure 3-11. To connect the drive to the board:
1. Insert the 40-pin cable/SATA connector into the mating connector of the
adapter board. Make sure that pin 1 of the connector matches with pin 1
on the cable.
2. Insert the other end of the cable into the header on the drive.
When inserting this end of the cable, make sure that pin 1 of the
cable connects to pin 1 of the drive connector.
3. Secure the drive to the system chassis by using the mounting
screws, as shown in Figure 3-12.
Pin 1
ATA-Bus
Interface Cable
Power Supply Cable
Figure 3-11
ATA-Bus
Interface
Connector
40-Pin Header
(3-Pin or 4-Pin)
Drive Power Supply and ATA Bus Interface Cables
Maxtor DiamondMax Plus9 60/80/120/160/200GB AT
Key Slot
DC Power
Connector
Installation
Bevel
3-19