Combination Connector (J1); Figure 3-8 Serial Ata Pcb - Maxtor DiamondMax Plus9 60GB AT Product Manual

3.4.5.1 SATA Bus Connector
Some PC motherboards have a built in SATA bus connector. These
SATA bus connectors are compatible with Maxtor DiamondMax Plus9
hard disk drives.If the motherboard has a SATA connector, simply
connect a 7 pin SATA cable between the drive and the motherboard.
3.4.5.2 Adapter Board
If your PC motherboard does not contain a built-in SATA bus interface
connector, you must install an SATA bus adapter board and connecting
cable to allow the drive to interface with the motherboard. Maxtor does
not supply such an adapter board, but they are available from several
third-party vendors.
Please carefully read the instruction manual that comes with your
adapter board to ensure signal compatibility between the adapter board
and the drive. Also, make sure that the adapter board jumper settings
are appropriate.
3.5

COMBINATION CONNECTOR (J1)

J1 is a three-in-one combination connector. The drive's DC power can
be applied to section A or B. Do not connect both a and b to power at
the same time. The SATA interface (7-pin) uses section C. The
connector is mounted on the back edge of the printed-circuit board
(PCB), as shown in Figure 3-6.
CAUTION:
Do not connect both A and B to power at the same time
Serial ATA PCB
Figure 3-8
Maxtor DiamondMax Plus9 60/80/120/160/200GB AT
Installation
3-13