3.3
HARDWARE OPTIONS
3.3.1
ATA Interface Connector
The configuration of a Maxtor DiamondMax Plus9 60/80/120/160/
200GB AT hard disk drive depends on the host system in which it is to
be installed. This section describes the hardware options that you must
take into account prior to installation.
ATA Interface Connector
Cable Select
Setting (default)
Master Setting
Slave Setting
DS with CS for
slaves not
supporting DASP
Figure 3-4
+12VDC
+12VDC return
+5VDC return
+5VDC
Pin 1
Pin 40
Jumper Locations on the ATA Interface Connector
Maxtor DiamondMax Plus9 60/80/120/160/200GB AT
Power
Connector
Note: this setting is identical
for both drive 0 and drive 1
Installation
3-5