Figure 3-11 Drive Power Supply And Ata Bus Interface Cables - Maxtor MaxLine Plus II 250GB AT Product Manual

To connect the drive to the board:
1. Insert the 40-pin cable/SATA connector into the mating connector of the adapter
board. Make sure that pin 1 of the connector matches with pin 1 on the cable.
2. Insert the other end of the cable into the header on the drive. When
inserting this end of the cable, make sure that pin 1 of the cable connects to
pin 1 of the drive connector.
3. Secure the drive to the system chassis by using the mounting screws, as
shown in Figure 3-12.
ATA-Bus
Interface
Connector
Pin 1
40-Pin Header
ATA-Bus
Interface Cable
Power Supply Cable
(3-Pin or 4-Pin)
Figure 3-11
Drive Power Supply and ATA Bus Interface Cables
Key Slot
DC Power
Connector
Maxtor MaXLine Plus II 250GB AT
Installation
Bevel
3-19