Figure 3-10 Drive Power Supply And Ata Bus Interface Cables - Maxtor DiamondMax 17 80 ATA Installation And Use Manual

3.6.1.1 Connecting the Adapter Board and the Drive
Use a 40-pin cable to connect the drive to the board. See figure 3-10.
To connect the drive to the board:
1. Insert the 40-pin cable connector into the mating connector of the adapter
board. Make sure that pin 1 of the connector matches with pin 1 on the cable.
2. Insert the other end of the cable into the header on the drive. When inserting
this end of the cable, make sure that pin 1 of the cable connects to pin 1 of the
drive connector.
3. Secure the drive to the system chassis by using the mounting screws.

Figure 3-10 Drive Power Supply and ATA Bus Interface Cables

Maxtor DiamondMax 17 80-160GB AT Hard Disk Drive
Installation
3-15