Folding And Storage; Braking System - X-TREME X-600 Owner's Manual

Electric scooters
Hide thumbs Also See for X-600:
Table of Contents

Advertisement

left/right side of the handlebars. Depressing the brake will disengage power to the
motor. When the unit feels like it is loosing power or not accelerating to full speed,
the scooter is ready to be re-charged.
NOTE: If the on/off switch is left in the ON position for more than 10-15 minutes without
moving, Smart Power will shut itself OFF. To reset, turn the unit OFF, wait a few seconds
and then switch it back ON again.
FOLDING & STORAGE
When you are done riding the X-600 you can fold it down for compact storage and
transportation. First remove the seat post and seat, then using one hand, push down on
the folding handle while gently pushing down on the handlebars. BE CAREFUL NOT TO
HIT YOUR HEAD WITH THE HANDLEBAR. Push down until you feel the mechanism
lock into the down position.

BRAKING SYSTEM

The X-600 uses a pinch braking system for the front, and a disc/caliper system
for the rear They are both activated by a hand brake lever on the left and right
side of the handlebar. Squeezing the hand brake lever with your left hand
activates the rear brake. Squeezing the hand brake lever with your right hand
activates the front brake. Make sure to release the HAND THROTTLE GRIP
when engaging the brakes. Your X-600 is equipped with switches on each
brake lever that will disengage power to the motor when the brake levers are
depressed.
Practice braking on a smooth, dry surface to get used to the feel of the braking
system. Braking distance is affected by wet conditions and loose and uneven
riding surfaces.
Adjusting the Brakes
The Brakes on the X-600 should come fully adjusted from the factory.
However, it may be necessary to adjust the brakes from time to time.
To adjust the rear brakes:
For brakes that are adjusted too loose:
1. Adjust the tension screw on the
right hand brake lever by rotating it
counter-clockwise until the wheel
spins freely.
For brakes that are adjusted too tight:
2. Tighten the tension screw on the
right hand brake lever by rotating it
clockwise until the wheel has a
slight drag.
Page10

Advertisement

Table of Contents
loading

Table of Contents