Table of Contents
Advertisement
CHARGING
Your scooter comes charged out of the carton. We still recommend charging the unit for
6-8 hours prior to it's first use. We also recommend charging your scooter after each use
and prior to storage.
WARNING: Do not allow your scooter to go into deep discharge, as this will damage the
batteries.
RIDING
1. Make sure that all of the exposed bolts and screws are tightened.
2. Raise the kickstand to its upright position.
3. Push the on/off switch (located on the left handlebar) to the ON position.
4. Put one foot on the deck of the X-600 while pushing off with the other foot, gently
rotate the THROTTLE GRIP, on the right side of the handlebars. The X-600 will begin
to move on its own power.
**Your scooter has a variable speed hand throttle. You can control the speed of your
scooter by the amount of pressure you use when rotating the hand throttle. The more
you rotate, the faster you will go.
STOPPING & BRAKING
1. To brake, release the THROTTLE GRIP and depress the BRAKE LEVERS (on the
1. Make sure unit is turned off.
2. Open the charging socket cover
located on the right side of the
scooter frame, under the footplate.
3. Locate
your
Find the charger socket end that
has a three-prong socket and plug
it into the scooter.
4. Next, plug the AC plug into a wall
outlet.
When first plugged in, the charger has one
red light that will illuminate at the same
time, indicating that the charging process
has started. Once the light on the charger
turns red & green, you may remove the
charger and close the safety cap.
Page9
Battery
Charger.
Advertisement
Table of Contents
