Eeprom Setup; Flash Rom Setup - SATO GL408e Programming Reference Manual

Unit 4: Standard Command Codes

EEPROM SETUP

FUNCTION Registers the operation of the printer in EEPROM.
FORMAT
<ESC>PG
Place immediately after <ESC>A.
EXAMPLE <ESC>A
<ESC>PG
<ESC>Z
OUTPUT This command does not result in printer output.
NOTES This command is not necessary with normal label printing. The operational settings
specified are still in effect after powering off the printer.
Refer to Appendix: Reference Table 29 for additional information.

FLASH ROM SETUP

FUNCTION Registers the operation of the printer in EEPROM.
FORMAT <ESC>PC
Place immediately after <ESC>A.
EXAMPLE
<ESC>A
<ESC>PC26,1
<ESC>Z
OUTPUT
This command does not result in printer output.
NOTES Go to the Advanced Mode or Service Mode for configuration. These command setting
will remain in effect after powering off the printer.
The entire or partial parameter entries is omissible by using commas for total settings.
Any commas that are omitted will result in those settings remaining as default.
Refer to Appendix: Reference Table 30 for additional information.
SATO GL4xxe SBPL Programming Reference Page 4-59