Rf Address Code Setting - Salus RT500RF Instruction Manual

Salus RT500RF Manual:89 9/7/10 10:10 Page 10

RF ADDRESS CODE SETTING

If there is another unit being used nearby, e.g. in the next house or as part
of a multiple installation, your Receiver may be fault triggered by the other
Control Unit. You can change the RF Address Code to help prevent this
problem.
Each Receiver can only respond to RF transmissions from a Control Centre
that has the same RF address code setting.
Disconnect any AC power to the Receiver, and remove the batteries from the
Control Centre before attempting any adjustment of the RF Address Code
switches and jumpers. If you are not sure how to carry out this operation
correctly, consult either with a qualified electrician or heating engineer.
To adjust the RF address code of the Receiver, simply push up one or more
of the 5 DIP switch levers on the DIP switch bank located on the back of the
receiver (the levers are numbered 1 to 5 from bottom to top, as shown in the
picture below), and then make a note of the setting of each switch:
RT500RF INSTRUCTION MANUAL
10