Setting Up Rf Communication - Salus rt505tx Instruction Manual

SETTING UP RF COMMUNICATION WITH
YOUR RECEIVER
RXRT505
(ONLY)
Receiver
DIP Switches
Jumper Caps
For full instructions on pairing the RXRT505 see page 7 of the receiver manual.
RXVBC605, RXWBC605,RXBC605 & RXST625
To enter pairing mode press and
hold SELECT for 3 sec and the
thermostat will show 10SY (see right)
once the thermostat is in pairing
mode press and hold the sync button
on the receiver (see page 14) wait for
the red LED on receiver to change
state then press any key to cancel
and return to the main screen.
RT505TX INSTRUCTION MANUAL
After you have switched the above receiver on,
the thermostat will automatically pair. When
the red LED stops flashing, the unit has
successfully paired.
If you have difficulty in pairing the thermostat,
we recommend changing the address codes in
the thermostat and the receiver.
To adjust the RF address code of the receiver,
simply push up one or more of the 5 DIP switch
levers on the DIP switch bank located on the
back of the receiver (the levers are numbered 1
to 5 from bottom to top, as shown in the picture
left), and then make a note of the setting of
each switch:
To adjust the RF address code of the thermostat,
remove one or more of the jumper caps located
on the back of the unit (labelled 1,2,3,4 and 5,
and shown in the picture left) so that the
jumper settings match the settings made on the
receiver:
13