Table of Contents
Advertisement
Installation
This switch can be mount in the rack or mount on the wall. You can
choose the suitable one to install your device.
Before installing the switch, we strongly recommend:
The switch is placed with appropriate ventilation environment. A minimum
25mm space around the unit is recommended.
1.
The switch and the relevant components are away from sources of
electrical noise such as radios, transmitters and broadband
amplifiers.
2.
The switch is away from environments beyond recommend moisture.
Wall mount Installation
1.
Screw the two provided screws into the wall 150 mm apart
horizontally. Leave a small gap between the head of the screw and
the wall. The gap should be big enough for the screw heads to slide
into the screw slots and the connection cables to run down the back
of the switch.
2.
Align the holes on the back of the switch with the screws on the wall.
Hang the switch on the screws.
Warning!
Do not wall mount the product vertically or it will be dangerous. Please
attach the product on the wall horizontally! See the image below for
reference:
Rack-mount Installation
Procedures to rack-mount the switch in the rack:
1.
First disconnect all the cables from the switch.
2.
Place the unit the right way up on a hard, flat surface with the front
facing you.
3.
Locate a mounting bracket over the mounting holes on one side of
the unit.
4.
Insert the screws and fully tighten with a suitable screwdriver.
5.
Repeat the two previous steps for the other side of the unit.
7
Advertisement
Table of Contents
