Mac Os X Users; Installing The Driver - Roland OCTA-CAPTURE Owner's Manual

Mac OS X Users

Steps to be performed on the OCTA-CAPTURE keyboard itself are marked by a
Operation of the OCTA-CAPTURE
until you are told to do so.
* What you actually see on the screen may differ depending on your system .

Installing the Driver

* During the installation process, when you are presented with a dialog box asking you to supply
your password, enter an administrator's password and click [OK] .
1. With the OCTA-CAPTURE disconnected, start up your computer .
Disconnect all USB cables from your computer, with the exception of those for a USB keyboard and
USB mouse (if used).
2. Close all currently running software .
3. Insert the included OCTA-CAPTURE CD-ROM into your DVD-ROM drive .
4. Double-click one of the following icons on the CD-ROM to start up the installer .
OS
Mac OS X 10 .6 or later
Mac OS X 10 .5 or earlier
A message concerned with checking whether installation is possible may appear.
If so, click [Continue].
If a message indicating that installation is not possible appears, check the operating system you're
using, and perform step 4.
5. The screen will indicate "Welcome to the OCTA-CAPTURE Driver Installer . " Click
[Continue] .
6. If the screen asks you to select a destination, click your start-up disk to select it, and
then click [Continue] .
7. When the display asks you to select the type of installation, click [Install] or [Upgrade] .
8. In the next screen, click [Continue Installation] .
9. When installation is completed, click [Restart] to restart your computer .
* It may take some time for your computer to restart .
symbol. Don't connect the OCTA-CAPTURE to your computer
Installer
[OctaCapture_USBDriver.pkg]
[OctaCaptureUSBDriver.pkg]
Folder
/Driver (10.6)
/Driver (10.4_10.5)
23