Problems When Two Units Are Connected - Roland OCTA-CAPTURE Owner's Manual

Problem What to check
Is the digital input switch turned "on"?
If you want to digitally capture audio data from a CD or MD into your computer,
turn on the digital input switch to select digital input mode (p. 60).
Does the OCTA-CAPTURE's sample rate setting match the sample rate setting of
the digital device from which you're trying to record?
Can't record via a
Set the OCTA-CAPTURE to the same sample rate as the device from which you're
digital connection /
recording. If you switch the OCTA-CAPTURE's sample rate, you must cycle the
Something is wrong
power to the OCTA-CAPTURE in order to make the new setting take effect.
with the recorded
sound
Is the OCTA-CAPTURE's system setting "DIGITAL" set correctly?
If the OCTA-CAPTURE is not correctly synchronized with the digital signal that's
being input to the digital input connector, the sync indicator will indicate
"INT. " In the Utility section, make sure that the "DIGITAL" setting is "AUTO. " Also
make sure that your digital device is correctly connected to the digital input
connector, and that a digital signal is being input.

Problems when Two Units are Connected

Problem What to check
Could a USB device other than the OCTA-CAPTURE units, a mouse, and a
keyboard be connected?
Make sure that all USB devices other than the OCTA-CAPTURE units, mouse, and
keyboard are disconnected from your computer.
Are both OCTA-CAPTURE units connected?
Are the OCTA-CAPTURE's "VS EXPAND" settings correct?
Set the first OCTA-CAPTURE unit's "VS EXPAND" to "OFF, " and the second unit to
"ON. "
Have you used a coaxial cable to connect the second unit's OUT (9/10) to the
ASIO or CoreAudio
first unit's IN (9/10)?
does not show the
Is the OCTA-CAPTURE's system setting "DIGITAL" set to "AUTO"?
audio ports of the
two units
In the OCTA-CAPTURE control panel's "Driver Settings, " check the "VS EXPAND"
item.
Check the connections as described in step 7 of "Connecting Two OCTA-
CAPTURE Units" (p. 63).
Check the device set settings (Mac OS X).
Check the Mac OS X settings as described in step 7 of "Connecting Two
OCTA-CAPTURE Units" (p. 63).
Have you selected "OCTA-CAPTURES" as the audio setting in your DAW
software?
(Mac OS X)
Page
p. 60
p. 68
p. 60
Page
−
−
p. 60
p. 63
p. 60
p. 63
p. 63
p. 65
91