Lutron Machine Description; Driver Scope Of Supply; Supplied By Fieldserver Technologies For This Driver; Provided By The Supplier Of - FieldServer Lutron Machine FS-8700-97 Driver Manual

FS-8700-97 Lutron Machine Manual
1

LUTRON MACHINE DESCRIPTION

The Lutron Machine driver allows the FieldServer to transfer data to and from devices over RS-232 using Lutron
eLumen protocol. The FieldServer can emulate either a Server or Client, although the Lutron Machine driver is
only available in Client configuration. Server drivers are for FieldServer testing purposes only.
Max Nodes Supported
FieldServer Mode
Client
Server
The Lutron Grafik Machine Zone/Area Machine driver, hereafter simply referred to as the Lutron Machine driver,
provides a BACNet IP interface to a Lutron eLumen panel. The driver can be configured to represent zones or
areas as used in the Lutron eLumen panel. The FieldServer acts as both Client and Server to provide BACNet
objects to an external BACNet Client. In Server mode, the FieldServer collects data from the eLumen panel and
holds the data ready for reads from an external BACNet Client. In Client mode, the FieldServer executes pre-
defined commands on the eLumen panel, for example, running scripts.
2

DRIVER SCOPE OF SUPPLY

2.1

Supplied by FieldServer Technologies for this driver

FieldServer Technologies PART #
FS-8915-10
FS-8917-03
2.2

Provided by the Supplier of 3

2.2.1 Hardware

Part # Description
Lutron eLumen Panel
r d

2.2.2 Required 3

Party Software

An external BACnet IP Client to interface to the Lutron Machine on the FieldServer.
r d
2.2.3 Required 3

Party Configuration

BACnet IP Client must be set up to access FieldServer over the network.
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com
Nodes Comments
Only one Lutron Machine driver Client node is able to be connected to a
1
Lutron eLumen panel.
1 One BACNet IP node provides an interface to the Lutron eLumen panel.
Description
UTP cable (7 foot) for RS-232 use
RJ45 to DB9F connector adapter
rd
Party Equipment
Page 3 of 24