Memory Names; Clearing The Memory Contents - Icom IC-A24 Instruction Manual

■ Memory names

ï Programming memory names
The memory channel can display a 6-character name in-
stead of the programmed frequency.
q In the frequency mode, rotate [DIAL] to select the desired
frequency in the frequency mode.
w Push , then push [MR•
into the selected memory channel.
e Rotate [DIAL] to select the desired memory channel to be
programmed.
• Push , then push [0•
BANK
BANK number, if desired. Push [CLR•
lection mode.
r Push [MR• ] to enter the memory name programming
MW
mode.
• "-- -- -- -- -- -- " appears on the display.
t Push the appropriate digit key several times to select the
desired character, as listed to the right.
• To erase a character, overwrite with a space (displayed as _).
• To move the cursor forwards or backwards, use [DIAL].
y Push [ENT• ] to program the name.
WX
• The memory name stops flashing.
• When no name is programmed, the display shows the operat-
ing frequency.
• To clear the entered memory names, push [CLR•
pushing [ENT• ].
WX
] to program the contents
MW
], and rotate [DIAL] to select the
] to exit the BANK se-
DEL
] before
DEL
MEMORY OPERATION
Key Character Key
1 1, Q, Z 2
4 4, G, H, I 5
7 7, P, R, S 8
ENT Program 0
NOTE: When programming the memory name to the pro-
grammed memory channel do the following.
q Follow the same steps as in "Transferring memory con-
tents" (see p. 12).
w Follow steps w–y in "Programming memory names"
(see left column).

■ Clearing the memory contents

Unwanted memory channels can be cleared.
q Select the memory channel to be cleared.
w Push , then hold down [CLR•
• "-- -- -- -- -- --" appears momentarily, then the next selectable
channel appears.
Character Key Character
2, A, B, C 3 3, D, E, F
5, J, K, L 6 6, M, N, O
8, T, U, V 9 9, W, X, Y
0, space, -
] for 1 sec.
DEL
4
4
14