Ricoh C6055 Operating Instructions Manual page 275

• p.273 "To change the IP-Fax Destination"
• p.273 "To change the protocol"
• p.273 "To program the SUB Code"
• p.274 "To program the SEP Code"
• p.274 "To set the International TX Mode"
• p.274 "To select the fax header"
Using the IP-Fax Destination as the sender
This section describes how to use the IP-Fax destination as the sender.
1. Press [Protection].
2. Press [Sender] under "Use Name as".
To change the IP-Fax Destination
This section describes how to change a registered IP-Fax destination.
1. Press [Change] under "Use Name as".
2. Enter the new destination, and then press [OK].
To change the protocol
This section describes how to select the protocol.
1. Press [Select Line].
2. Select [H.323] or [SIP].
To program the SUB Code
This section describes how to program the SUB Code.
1. Press [Adv. Features], and then press [SUB Code].
2. Press [Change] under "TX SUB Code".
3. Enter the SUB Code, and then press [OK].
4. To enter a password, press [Change] under "Password (SID)".
5. Enter a password using the number keys, and then press [OK].
6. Press [OK].
Fax Destination
7
273