Table of Contents
Advertisement
Auger Housing Reset Height Position
This snowblower allows you to change the auger housing reset height
position (the position where the auger housing returns when you push
the reset switch) as needed.
Change the reset height position (auger housing return position set at
present) in case of the following.
1.
When you do not want to lower the auger housing to be level to the
ground, as the gravel can be caught in the auger during clearing on
a graveled ground.
2.
When the scraper/skid position was changed, making the reset
height position no longer adequate for clearing the snow.
3.
When each part of the snowblower is worn, making the reset height
position no longer adequate for clearing the snow.
4.
When you want to change the reset height position to a position you
want.
Park the snowblower on firm, level ground to change the reset height
position.
P
P
u
u
s
s
h
h
f
f
o
o
r
r
5
5
s
s
e
e
c
c
.
.
RESET SWITCH
o
o
r
r
l
l
o
o
n
n
g
g
e
e
r
r
1.
Turn the engine switch to the ON
position (see page
2.
Push the reset switch and hold it
pushed for five seconds or longer.
The auger housing moves to
the reset height position by
pushing the reset switch. Keep
pushing the reset switch.
3.
Release the reset switch and
check whether the reset switch
indicator is blinking.
OPERATION
40
).
63
Advertisement
Table of Contents
