Table of Contents
Advertisement
8.
Reinstall the batteries in their original position.
9.
Connect one battery joint cable terminal at the battery A positive ( )
terminal, and connect the other cable terminal at the battery B
negative ( ) terminal.
10.
Reinstall the battery set plate and tighten the nuts.
11.
Connect the positive ( ) cable at the battery B positive ( ) terminal,
and then the negative ( ) cable at the battery A negative ( )
terminal.
12.
Coat the battery terminals with grease.
13.
Reinstall the rear cover by aligning the grommets with the
projections of the rear cover, and tighten the knobs securely.
SPRING
Install the upper side of the rear
cover between the right and left
springs.
When disconnecting the battery cable, be sure to disconnect the
battery negative ( ) terminal first. Connect the positive ( ) terminal
first, then the negative ( ) terminal. Never disconnect the battery
cables in the reverse order; that could cause a short circuit if a tool
contacts the terminals.
SERVICING YOUR SNOWBLOWER
REAR COVER
GROMMET
PROJECTION
KNOBS
REAR COVER
PROJECTION
GROMMET
93
Advertisement
Table of Contents
