Honda HS1336i Owner's Manual page 122

TAKING CARE OF UNEXPECTED PROBLEMS
SYMPTOM
Snow discharge
chute does not
throw snow well.
Auger runs up onto
and does not cut
into hard snow.
Auger housing
becomes clogged
with snow.
Auger is in contact
with the road
surface.
Snowblowing
mechanism makes
an abnormal noise.
Snow discharge
chute direction can
not be set.
120
POSSIBLE CAUSE
Engine is overloaded.
MANUAL mode only
Engine speed is too low.
MANUAL and POWER
mode only
Blower is deformed.
Blower shear bolt is
broken.
Auger shear bolt is broken.
Snow discharge chute is
angled down.
Auger height is not proper.
Auger shear bolt is broken.
Auger is worn.
Blower shear bolt is
broken.
The height of skid and
scraper is not proper.
Auger height is not
adjusted properly.
Skid and scraper height is
not adjusted properly.
The shape of the shaft and
wing of the auger and/or
blower is deformed.
Right control unit is faulty.
Motor is overheated
(breaker tripped).
Motor or switch or relay is
faulty.
REMEDY
Lower the driving speed (see
page 65 ).
Move the throttle control lever
to the FAST position (see page
52 or 55 ).
Replace the blower (see page
87 ).
Replace the blower shear bolt
(see page 86 ).
Replace the auger shear bolt
(see page 86 ).
Adjust so that the snow
discharge chute is angled up
(see page 25 ).
Adjust the auger height (see
page 45 ).
Replace the auger shear bolt
(see page 86 ).
Replace the auger (see page 87 ).
Replace the blower shear bolt
(see page 86 ).
Adjust the skid and scraper (see
page 43 44 ).
Adjust the auger height (see
page 45 ).
Adjust the skid and scraper (see
page 43 44 ).
Consult an authorized Honda
dealer.
Consult an authorized Honda
dealer.
Wait for a while. Do not keep
pushing operation lever.
Consult an authorized Honda
dealer.