Grizzly g0623X Owner's Manual page 39

blade guard installation & removal
the blade guard fits over the riving knife and is
secured in place with an m10-1.5 x 25 cap screw
and an m10-1.5 lock nut (see "mounting screw"
in figure 56). these are the only fasteners that
need to be installed/removed when installing or
removing the blade guard.
mounting
screw
figure 56. blade guard mounted to riving knife.
When installing the blade guard, the mounting
screw and lock nut must be left loose enough
that the guard can freely pivot up and down, but
not so loose that there is side-to-side play when
pivoting.
Model G0623X/G0623X3 (Mfg. Since 5/12)
testing guard for correct operation
after installing the blade guard, you must verify
that it functions correctly before making a cut. to
test the blade guard operation, lift up the front end
about 4" then release it.
• if the blade guard freely drops down against
the table surface, then it is functioning cor-
rectly and is ready for operation.
• if the blade guard remains in the position
where you released it, or it does not drop
down against the surface of the table, then
the mounting screw and lock nut are too tight.
loosen it slightly and repeat this test until the
guard functions correctly.
• if the blade guard feels loose and easily
moves back and forth as you raise it, then the
mounting screw and lock nut are too loose.
tighten it slightly and repeat this test until the
guard functions correctly.
For Your Own Safety Read Instruction
Manual Before Operating Saw
a) Wear eye protection.
b) Use saw-blade guard and spreader for
every operation for which it can be used,
including all through sawing.
c) Keep hands out of the line of saw blade.
d) Use a push-stick when required.
e) Pay particular attention to instructions
on reducing risk of kickback.
f) Do not perform any operation freehand.
g) Never reach around or over saw blade.
-37-