36. use a straightedge to make sure the riving
knife and scoring blade are aligned with the
main blade. the alignment should be with the
blade bodies, not the carbide teeth.
—the riving knife position can be changed by
adjusting the setscrews at the riving knife
mounting block. refer to page 71 for more
details.
—the scoring blade alignment can be
changed by adjusting the set screws acces-
sible through the table top (see figure
42).
scoring blade
alignment
scoring blade elevation
figure 42. access holes for scoring blade
adjustment controls.
Model G0623X/G0623X3 (Mfg. Since 5/12)
scoring Controls lock
37. install the blade guard on the riving knife, as
shown in figure 43, with the m10-1.5 x 25
cap screw an m10-1.5 lock nut shipped in
the blade guard. (the blade guard/dust hood
must be installed.)
figure 43. blade guard installed.
38. assemble miter gauge and push handle as
shown in figure 44.
push handle
figure 44. push handle and miter gauge
installed.
miter gauge
-29-