Grizzly g0623X Owner's Manual page 30

29. adjust the feet downward so they press
against the floor, then tighten the hex nuts up
against the support leg so the feet are locked
in place.
30. open the cabinet door and remove the motor
shipping brace shown in figure 37.
figure 37. motor shipping brace.
31. tilt the blade assembly to 0˚, then slide the
sliding table forward all the way until you can
open the lower blade guard cover and access
the blade arbors.
32. insert the arbor lock tool into the hole shown in
figure 38, rotate the arbor until the arbor lock
tool seats, then install the main blade, using
the included arbor wrench. there must be
an arbor flange on both sides of the blade.
figure 38. installing main blade.
-28-
arbor
lock
tool
33. insert the arbor lock tool into the hole shown
in figure 39, rotate the arbor until the arbor
lock tool seats, then install the scoring blade,
using the arbor wrench. there must be an
arbor flange on both sides of the blade.
arbor
lock
tool
figure 39. installing scoring blade.
34. install the riving knife as shown in figure 40,
but do not tighten the mounting bolt yet.
figure 40. installing riving knife.
35. adjust the riving knife approximately
from the main blade, using a
wrench as a guide (figure 41).
figure 41. adjusting the riving knife spacing.
Model G0623X/G0623X3 (Mfg. Since 5/12)
⁄ " away
1
8
⁄ " or 3mm hex
1
8