Grizzly g0623X Owner's Manual page 29

24. remove the shipping brace from the sliding
table (figure 32), then install the sliding table
end cover over the fixed part of the sliding
table end, as shown in figure 33, using the
premounted hardware.
figure 32. sliding table shipping brace.
figure 33. sliding table end cover installed.
25. attach the sliding table handle, as shown in
figure 34, with two button head screws and
flat washers, using the premounted hard-
ware.
figure 34. sliding table handle attached to end
of sliding table.
Model G0623X/G0623X3 (Mfg. Since 5/12)
shipping brace
button head
Cap screws
26. thread two m5-.8 x 12 cap screws with 5mm
lock washers through the switch bracket and
into the sliding table base, and tighten the
cap screws (see figure 35).
figure 35. magnetic switch installed.
27. thread the feet all the way into the bottom of
the support legs. do Not remove the hex
nuts pre-installed on the bottom of the feet,
since they will be used after the legs are
installed.
28. thread two m10-1.5 x 30 cap screws and
10mm lock washers through each support
leg and part way into the t-slot plates for
the legs, slide the t-slot plates into the both
ends of the sliding table base, and tighten the
mounting cap screws (see figure 36).
figure 36. support leg installed (1 of 2 shown).
magnetic
switch
support leg
-27-