Section 2 General Information; Introduction; Applications - Generac Power Systems Mobile Link Unit Owners And Installation Manual

Section 2 General Information

2.1 - Introduction

With this remote monitoring system, the status of the generator can
be checked from anywhere that the owner has access to an Internet
connection from a PC or while traveling with any smart device.
The unit is mounted on the outside of the generator and communi-
cates with the generator's controller via a serial port. It provides infor-
mation about the generator. When the generator is registered with
www.StandbyStatus.com, the owner can log into this website to
check on the current status of the generator at any time. It will also
notify the owner of any change in operating status. The owner will be
contacted if alarms or warnings occur. When a change in the genera-
tor's status occurs, an e-mail or text message is sent. The delivery
method and frequency of these alerts can be adjusted on the website.

2.2 - Applications

• This unit can be installed on all 2008 and later air-cooled home
standby units, with an LCD display, and all 2010 and later liq-
uid-cooled gaseous fuel standby units.
• For liquid-cooled units, an additional adapter harness is
required (model 006478-0).
• Suitable for flat surface or surface with a 1355mm radius mini-
mum, mounting in a Type 3R or rainproof enclosure.
• Power supplied by the engine starting battery is limited to 5
Amps DC by a fuse in the Mobile Link unit's harness. The fuse
is used for overcurrent protection of the Mobile Link unit hard-
ware.
• Maximum ambient temperature rating: 122
8
° °
F/50 C.
Mobile Link