Qlogic SANbox 3810 Installation Manual page 83

A
Heartbeat LED
A chassis LED that indicates the status of
the internal switch processor and the
results of the Power-On Self-Test.
Initiator
The device that initiates a data exchange
with a target device.
In-Order-Delivery
A feature that requires that frames be
received in the same order in which they
were sent.
Input Power LED
A chassis LED that indicates that the
switch logic circuitry is receiving proper DC
voltages.
IP
Internet Protocol
LIP
Loop Initialization Primitive sequence
Maintenance Button
Momentary button on the switch used to
reset the switch or place the switch in
maintenance mode.
Maintenance Mode
Maintenance mode sets the IP address to
10.0.0.1 and provides access to the switch
for maintenance purposes.
Management Information Base
A set of guidelines and definitions for
SNMP functions.
Management Workstation
PC workstation that manages the fabric
through the fabric management switch.
MIB
Management Information Base
59268-00 A
SANbox 3810 Fibre Channel Switch
Network Time Protocol
A network protocol that enables a client to
synchronize its time with a server.
NL_Port
Node Loop Port. A Fibre Channel device
port that supports arbitrated loop protocol.
N_Port
Node Port. A Fibre Channel device port in
a point-to-point or fabric connection.
NTP
Network Time Protocol
Pending Firmware
The firmware image that will be activated
upon the next switch reset.
Port Binding
An authorization method that defines a list
of device WWNs that can login to a switch
port.
POST
Power-On Self Test
Power-On Self Test
Diagnostics that the switch chassis
performs at start up.
Principal Switch
The switch in the fabric that manages
domain ID assignments.
QuickTools
Browser-based switch management appli-
cation that resides in the switch firmware.
Remote Authentication Dial-in Server
A server that supports the remote authenti-
cation of user and device logins to a
switch.
Installation Guide
Glossary-3