Fatal Post Error Blink Pattern; Configuration File System Error Blink Pattern - Qlogic SANbox 3810 Installation Manual

Fibre channel switch

Hide thumbs Also See for SANbox 3810:

Table of Contents

Diagnostics/Troubleshooting

Power-On Self Test Diagnostics

Fatal POST Error Blink Pattern

A system error blink pattern is 3 blinks followed by a two second pause. The

3-blink error pattern indicates that a POST failure or a system error has left the

switch inoperable. If a system error occurs, contact your authorized maintenance

provider. Momentarily press and release the Maintenance button to reset the

switch.

A configuration file system error blink pattern is 4 blinks followed by a two second

pause. The 4-blink error pattern indicates that a configuration file system error has

occurred, and that the configuration file must be restored.

To restore the switch configuration, do the following:

Establish communications with the switch using Telnet. Enter one of the

following on the command line:

telnet xxx.xxx.xxx.xxx

telnet switchname

where xxx.xxx.xxx.xxx is the switch IP address and switchname is the switch

name associated with the IP address.

A Telnet window opens prompting you for a login. Enter an account name

and password. The default account name and password are admin and

password.

Open an admin session to acquire the necessary authority.

SANbox $>admin start

Restore the configuration. When the restore is complete, the switch will

reset.

SANbox (admin) $>config restore

If a configuration does not exist, enter the Config Backup command, then

enter the Config Restore command.

4-4

2 seconds

59268-00 A

Table of Contents