Yamaha RX-V1200 Owner's Manual page 65

You can adjust the output level of each effect speaker
(center, left and right rear and subwoofer) while listening
to a music source.
Adjustment should be made with the remote control.
2
2
3
[] Press AMP to select the AMP
AMP mode.
Press LEVEL repeatedly to select the
speaker(s) you want to adjust.
Each time you press LEVEL, the selected speaker
changes and appears on the front panel display and
on the video monitor as follows: center, right rear,
rear center, left rear and subwoofer.
LEVEL
r:Ei,i"iEi,i: Center
speaker output
level
0,
r', ..".i i r', Right rear speaker output
r-. .:-= L." i".. level
r-, t-" ,"_t-', ,-'. -t- Rear center speaker output
i"2 1 =' i'i i_: i , i
............. level
0,
i ,::' i i r', Left rear speaker output
I... ..., _.j14.. level
g
="i i i-' r":
.':=i.'4 i- i"; Subwoofer output level
FJ
Press < / > to adjust the speaker output level.
• The control range for the center or left and right
rear speakers is from +10 dB to -10 dB.
• The control range for the subwoofer is from 0 dB
to -20 dB.
A
V
• When the speaker output modes fbr "l A CENTER SP" and
"lC REAR L/R SP" are set to NONE, and "lE LFE/BASS
OUT" to MAIN, the output level of those speakers cannot be
adjusted because there is no sound coming from these speakers.
• When you adjust the output level with LEVEL, the settings you
made with the test tone will be changed.
• It is recommended to adjust the speakers (except for a
subwoofer) by following the steps described in Using the Test
Tone on pages 23 and 24.
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is in the standby
mode. However if the power cord is disconnected from
the AC outlet, or the power supply is cut for more than
one week, the stored data will be lost. If so, set the
output level again.
\1/
• Once you press LEVEL, you can also select the speaker(s) to
be adjusted by pressing v //,..
^
LEVEL i?i!;.
< >
63