Be sure to connect
the left channel
(L), fight channel
(R), "+" (red) and "-" (black) properly.
If the connections
are
faulty, no sound will be heard from the speakers,
and if the polarity
of the speaker
connections
is incorrect,
the sound
will be unnatural
and lack bass.
• Use speakers
with the specified
impedance
shown
on the rear panel of this unit.
• Do not let the bare speaker
wires touch each other and do not let them touch any metal part of this unit. This could
damage
this unit and/or speakers.
If necessary,
use the SET MENU
to change
the speaker
mode settings
according
to the number
and size of the speakers
in your configuration
after you finish connecting
your speakers.
•
Speaker
cables
A speaker cord is actually a pair of insulated cables
running side by side. One of the cables is colored or
shaped differently, perhaps with a stripe, groove or ridge.
U
Remove approximately
10 mm (318") of
insulation from each of the speaker cables.
[]
Twist the exposed wires of the cable
together to prevent short circuits.
Connecting
to the SPEAKERS
terminals
Red: positive (+)
[]
Unscrew
the knob.
Black: negative (-)
[]
Insert
one bare wire into the hole in the side
of each terminal.
Tighten
the knob to secure
the wire.
Banana plug
(U.S.A., Canada, Australia, China and General models only)
• Banana plug connections are also possible. First, tighten the
knob and then insert the banana plug connector into the end of
the corresponding terminal.
•
MAIN SPEAKERS
terminals
One or two speaker
systems
can be connected
to these terminals.
If you use only one speaker
system,
connect
it to either
of the MAIN A or B terminals.
•
REAR SPEAKERS
terminals
A rear speaker
system
can be connected
to these terminals.
•
CENTER
SPEAKER
terminals
A center speaker
can be connected
to these terminals.
•
REAR CENTER
SPEAKER
terminals
A rear center
speaker
can be connected
to these terminals.
n
11