Yamaha RX-V1200 Owner's Manual page 16

Never connect this unit and other components to mains power until all connections between components have been
completed.
Be sure all connections are made correctly, that is to say L (left) to L, R (right) to R, "+" to "+" and "-" to "-". Some
components require different connection methods and have different jack names. Refer to the operation instructions
for each component to be connected to this unit.
When you connect other YAMAHA audio components (such as a tape deck, MD recorder and CD player or
changer), connect them to the jack with the same number labels as [_, %, [] etc. YAMAHA applies this labeling
system to all its products.
After you have completed all connections, check them again to make sure they are correct.
• About the video jacks
There are three types of video jacks. Video signals input through the VIDEO jacks are the conventional composite video
signals. Video signals input through the S VIDEO jacks are separated into luminance (Y) and color (C) video signals.
The S-video signals achieve high-quality color reproduction. Video signals input through the COMPONENT VIDEO
jacks are separated into luminance (Y) and color difference (P_/CB, P_/Ck) video signals. The jacks are also separated
into three for each signal. The description of the component video jacks may be different depending on the component
(e.g. Y, C_, CR/Y, P_, PR/Y, B-Y, R-Y etc.). Component video signals provide the best quality in picture reproduction.
VIDEO COMPONENT VIDEO
SWDEO WDEO PR/CR PB/CB Y
@@ @@ @
SVIDEO VIDEO jack COMPONENT
jack (composite) VIDEO jacks
If your video component has an S-video output or component video output, you can connect it to this unit. Connect the
S-video signal output jack on your video component to the S VIDEO jack or connect the component signal output jacks
on your video component to the COMPONENT VIDEO jacks.
\11
• Each type of video jack works independently. Signals input through the composite
video, S-video and component jacks are output through the corresponding composite
video, S-video, and component jacks, respectively.
• You can designate the input for the COMPONENT VIDEO A and B jacks according
to your component by using "7 I/O ASSIGNMENT" on the SET MENU (see pages
58 and 59 for details).
• Use a commercially available S-video cable when connecting to the S VIDEO jack, and commercially available video cables when
connecting to the COMPONENT VIDEO jacks.
• When you are using the COMPONENT VIDEO jacks, check the details in the owner's manual that came with the component being
connected.
VIDEO AUX jacks (on the front panel)
@ _0E; ............. These jacks are used to connect any video input source
such as a game console and a camcorder to this unit.
[
_ AUDIO OUT R! _ I-
AUDIO OUT L I
: I 1@
VIDEO OUT
Game
console or
camcorder
_ SVIDEO OUTI ,_ L r'_
14