Yamaha RX-V1200 Owner's Manual page 55

Depending on the item, press/,,Iv to select a sub
item.
A
G
Z LUi_,i i"Ki;,!i L::,i
TEST TOiiE- . _ OFF
0 LI T PU T, i! fi ! N L P
FPQ ........ 88Hz
_1 Press < / } repeatedly to change the setting
of the item.
A
v
2 L0U FF,:Q TEST
:_TF'L_ _ ItPiti L'F:
b P: !A........ U U H z
[] Press A/v repeatedly until the menu
disappears or simply press one of the DSP
program group button to exit from the SET
MENU.
A
<@> or
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is in the standby
mode. However if the power cord is disconnected from
the AC outlet, or the power supply is cut for more than
one week, the stored data will be lost. If so, adjust the
items again.
-1-ilt_1:111'
Use this feature to select suitable output modes for your
speaker configuration.
• When 96-kHz sampling digital signals are input to this unit,
level adjustments in items 1B, 1E and 1F are possible, but those
in items IA,IC and ID are not affected.
• When 6CH INPUT is selected as the input source, level
adjustments in items IA through IE are not affected.
• 1A CENTER SP (center speaker
mode)
By adding a center speaker to your speaker configuration,
this unit can provide good dialog localization for many
listeners and superior synchronization of sound and
images. The OSD shows a large, small or no center
speaker depending on how you set this item.
Choices: LRG (large), SML (small), NONE
Initial setting: LRG
LRG
Select this if you have a large center speaker. The entire
range of the center channel signal is directed to the center
speaker.
iA CEi,iTER SF'
_'LF:G $_!L HOHE
SML
Select this if you have a small center speaker. The low-
frequency signals (90 Hz and below) of the center
channel are directed to the speakers selected with "IE
LFE/BASS OUT".
iA CEi,iTER SF'
LF:G I,,E;P!L HOHE
53