Rear Panel - Yamaha RX-V1200 Owner's Manual

Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal
strength.
Connect each antenna correctly to the designated terminals.
FREQUENCY STEP switch (China and General
models
only)
Because the interstation frequency spacing
differs in different areas, set the
FREQUENCY STEP switch (locating on
the rear panel) according to the frequency
spacing in your area.
North, Central and South America:
100 kHz/10 kHz
Other area: 50 kHz/9 kHz
Before setting this switch, disconnect the
AC power plug of this unit from the AC
outlet.
AM loop antenna _
(included) Indoor FM
antenna
(included)
(U.S.A. model)
• Connecting the AM loop antenna
[] Set up the AM loop antenna, then connect it.
[] Press and hold the tab to insert the AM loop
antenna lead wires into the AM ANT and
GND terminals.
[] Orient the AM loop antenna for the beat
reception.
\t/
• The AM loop antenna can be removed from the stand and
attached to a wall, etc.
For maximum safety and minimum
interference, connect the antenna GND
terminal to a good earth ground. A good
earth ground is a metal stake driven into
moist earth.
• Connecting the indoor FM
antenna
Connect the included indoor FM antenna to the 75_
UNBAL. FM ANT terminal.
The AM loop antenna should be placed away from this unit.
The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
A properly installed outdoor antenna provides clearer
reception than an indoor one. If you experience poor
reception quality, an outdoor antenna may improve the
quality. Consult the nearest authorized YAMAHA
dealer or service center about the outdoor antennas.
36