Using The Remote Control - Yamaha RX-V1200 Owner's Manual

BF.7_-'_ T_?_iiF.7-"H q'
Main B speaker Main A speaker
Right Left Right Left
Subwoofer
system
I I
®
(U.S.A. model) (_
®
®©
® ®
Center
speaker
Rear Center Right Left
speaker Rear speaker
• SUBWOOFER jack
When using a subwoofer with built-in amplifier, including the YAMAHA Active Servo Processing Subwoofer System,
connect the input jack of the subwoofer system to this jack. Low bass signals distributed from the main, center and/or
rear channels are directed to this jack if they are assigned to this jack. (The cut-off frequency of this jack is 90 Hz.) The
LFE (low-frequency effect) signals generated when Dolby Digital or DTS is decoded are also directed if they are
assigned to this jack.
• Adjust the volume level of the subwoofer with the control on the subwoofer. It is also possible to adjust the volume level by using the
remote control of this unit (see ADJUSTING THE LEVEL OF THE EFFECT SPEAKERS on page 63).
• Depending on the settings of "1 SPEAKER SET" and "10 LFE LEVEL" on the SET MENU, some signals may not be output from
the SUBWOOFER jack.
The diagram above shows the speaker layout in the
listening room.
12